Replacing Audi Q2 C Pillar Blades

All Audi Q2 related discussions
Post Reply
Posts: 1
Joined: Fri Jun 28, 2019 6:31 am

Replacing Audi Q2 C Pillar Blades

Post by BevJ » Fri Jun 28, 2019 6:37 am

I have purchased new Black Carbon fibre C Pillars to replace the Matt grey ones - does anyone know how to remove the old ones, tried to find on YouTube but no videos - Please help - thank you

Posts: 50
Joined: Tue Oct 23, 2018 7:59 pm
Location: Northumberland

Re: Replacing Audi Q2 C Pillar Blades

Post by testcard » Fri Jun 28, 2019 7:07 am

Some basic instructions here.
2019 Audi Q2 S line, 35 TFSI. Daytona grey.

Posts: 1
Joined: Wed Jul 31, 2019 2:41 pm

Re: Replacing Audi Q2 C Pillar Blades

Post by Quattro19 » Wed Jul 31, 2019 2:51 pm

I have just bought some new C-Pillar trims too (not received yet) but I have been sent this guide.
The seller also recommends this job is carried out by an official Audi garage!


Posts: 119
Joined: Thu Feb 16, 2017 4:58 pm

Re: Replacing Audi Q2 C Pillar Blades

Post by IanQ2 » Wed Jul 31, 2019 3:59 pm

I have had mine off a few times (I have custom carbon ones not the Audi ones)

If you look at the new ones you will see how they are attached. its basically a few orange plastic clips that push into the body and then a couple of white clips from memory which tend to break.

It just takes a bit of brute force to get them off, start at the door end and pop the clips out the holes then just pull hard has been the method I've used. They have a strip of double sided tape from factory down the back edge next to the boot opening.

If you want the official Audi method you can download the workshop manual on but it will cost you for an hours use.

Posts: 7
Joined: Mon Jul 15, 2019 10:47 pm

Re: Replacing Audi Q2 C Pillar Blades

Post by frazzeld » Thu Aug 08, 2019 8:24 pm

How much were the carbon blades.. must have been expensive

Post Reply

Return to “Main Audi Q2 chat”